Home            Workshop   Solutions                                        



The Camera Holder


Originator......Tom Jeary.

E-mail............tlj@golden.net


THE PROBLEM:   To to allow a person with limited or no use of hands to operate a camera.

THE SOLUTION:  The device shown in the  left diagram  is made from plastic ( lexan ) ,heated and bent to fit snugly over the users hand. a velcro strap (male) with a ring attached pulls around to a velcro (female) pad to hold the camera firmly in place.The holder is screwed into the threaded hole on all cameras used to mount on a tripod. A thin rubber rubber plate helps to gripholder to camera or, in this case the camera is only being used by the one person so the holder is more permanently bonded on with silicon.

Home            Workshop    Solutions